Technical Details
| Principal Dimensions and Characteristics |
| |
Length Over All: |
21.03 m
|
69 feet |
| |
Beam: |
7.92 m |
26 feet |
| |
Depth: |
2.43 m
|
8 feet |
| |
GRT / NRT: |
96 / 76
|
| |
Year Built: |
2008, USA |
| |
Hull Construction & Tank Capacities: |
| |
Design: |
Steel hull. Square bow with push knees. |
| |
3 level cabin. |
| |
Deck: |
5/16” original thickness. |
| |
Sides: |
5/16” original thickness. |
| |
Bottom: |
3/8” forward with ½” original thickness aft. |
| |
Frames: |
3” x 3/8” flat bar transversely. |
| |
Fuel Oil: |
60,567 liters |
16,000 gallons |
| |
Freshwater: |
98,421 liters |
26,000 gallons |
| |
Height of eye: |
7.92 m |
26 feet |
| Main Propulsion Machinery |
| |
Main Engines (3) |
|
| |
Make/Model: |
Mitsubishi six cylinder diesel engines |
| |
Power @ 2,000 RPM |
320 kW x 3 |
429 hp x 3 |
| |
Gearbox: |
| |
Make/Model: |
Tonanco / TM 828D |
| |
With a 4:65:1 ratio and a hydraulic clutch. |
| |
Side Ferstrum cooling system. |
| |
Electric starters. |
| |
Propellers: |
4” diameter shaft with reported 48” x 46” 5-blade Aqua Lloyd |
| Auxiliary Machinery & Equipment |
| |
Vessel is outfitted as follows: |
| |
45-gallon electric water heater. |
| |
Piggyback washer and dryer units. |
| |
One (1) approximate 10 hp electric motor driving a fire pump. |
| |
One (1) freshwater pressure pump driven by a fractional HP electric motor. |
| |
One (1) 3 hp electric motor driving a bilge pump. |
| |
One (1) 3 hp electric motor driving a transfer water pump. |
| |
One (1) 3 hp electric motor driving a fuel pump with a Nu-Flo meter. |
| |
One (1) 3.2 hp electric motor driving a Husky Pro air compressor. |
| |
Two (2) Mitsubishi 4-cylinder diesel engines driving 30 KW Stamford generator sets each. |
| |
Two (2) 10 hp electric motors driving hydraulic steering pumps each. |
| |
Two (2) 10 hp electric motors driving hydraulic pumps for deck winches. |
| |
Two (2) 12-volt starter marine type batteries and six (6) 12-volt heavy-duty batteries. |
| |
Two (2) ventilation supply fans for the engine room driven by fractional hp electric motors each. |
| |
Steering system: Mechanical hydraulic with two (2) steering rams and jockey bar. |
| |
Main switch panel dated 10-25-07. |
| |
General alarm system. |
| |
A lead sewage treatment unit with fractional hp electric motor. |
| |
Three (3) fractional HP electric motors drive automatic Rule pumps below each shaft. |
| |
One (1) Carrier central air-conditioning unit. |
| |
Two (2) Nabrico deck winches driven by 10 hp hydraulic motors each. |
| |
Two (2) 500-watt deck lights facing aft and two (2) facing forward. |
| |
One (1) approximate 1 hp electric motor drives a ventilation fan aft. |
| Fire Fighting Equipment |
| |
One (1) 5 lb. CO² fire extinguisher located in the wheelhouse. |
| |
Three (3) exterior fire stations and one (1) interior engine room fire station with hose and nozzle each. |
| |
One (1) 5 lb. CO² fire extinguisher in the deckhouse on the 2nd level. |
| |
One (1) 10 lb. CO² fire extinguisher in the galley. |
| |
Two (2) 20 lb. CO² fire extinguishers in the engine room. |
| |
One (1) fire axe. |
| |
Fire alarm and Fire-Lite MS-2 system. |
| Fender System |
| |
Fender system consists of 8” x 1” flat bar rubrail around the perimeter. Sandwich tire fender
systems are located around the perimeter of the headlog and forward & aft corners. Tires are located on each side and aft for added hull protection. |
| Deck Fittings |
| |
Deck fittings are as follows: |
| |
Three (3) sets of double steel bitts located on each port and starboard side. |
| |
One (1) set of double steel bitts located forward and aft on centerline. |
| |
Push knees with steps and railing on each side forward and make up buttons on top. |
| |
Make up button each port and starboard side forward. |
| |
Fuel oil fills and piping are boxed in. |
Hydraulic Dredges
