191016-DB

16 x 12 Cutter Suction Dredger

This 16 x 12 Cutter Suction Dredger is a dismountable cutter suction dredger. The dredger has kicker spuds, allowing the dredger to be advanced without walking the dredger. Built in 2013 but not put into operation until 2014. The working hours is 6,800. The main pump was updated in 2020.

Located in Northern Europe

Select Your Currency:

Price in Seller's Preferred Currency:

USD 475,000

Price in Your Preferred Currency:

USD 475,000

Technical Details


Principal Dimensions and Characteristics
	Length Hull:	12.00 m	39-ft
	Length Overall:	18.00 m	59.05-ft
	Beam:	4.80 m	16-ft
	Depth:	1.50 m	5-ft
	Mean Draft (w/full bunkers) approx.:	0.88 m	3-ft
	Dredging Depth:	11.00 m	36-ft
	Ladder Length:	14.5 m	47-6-ft
	Total Dry Weight:	approx. 40 tons
Main Engine
	Make/Model:	CAT C18 INDM
	Power @ 2,200 RPM:	597 kW	800 hp
	Diesel Fuel Capacity:	8000 ltr	2113 gals
Dredge Pump
	Make/Model:	16/12HG-II-(7)-850R-230-???
	Impeller diameter:	850 mm	33.5-inch
	Shaft Power @ 750 RPM:	800 kW	1,073 hp
	Pump Capacity:	3400 m3/hr	4447 yd3/hr
	Suction Pipe Diameter:	400 mm	16-inch
	Discharge Pipe Diameter:	304.8 mm	12-inch
Gear Box
	Make/Model:	ZF 500
	Type:	Vertical offset, direct mount marine transmission
Cutter
	Cutter Diameter:	1,200 mm	47-inch
	Material:	High manganese steel
	Number of Cutter Blades:	5
	Drivers:	Hydraulic Motor
	Cutter Power:	30 kW	40 hp
Service Pump
	Make/Model:	VARISCO (Italia) / N2SG 40-26.264
	The service pump is provided to supply flushing water to the dredge pump packing gland, water to the cutter drive bearings and for a use at a deck connection.
	The hydraulic pump is a 2-section pump that provides service to the cutter head motor, swing winches, spud winches and ladder winch. The hydraulic system is protected by relief valves and the system has replaceable inline filters. The hydraulic system has an approximate capacity of 400 liters (106 gallons).
Electrical System
	The electrical system consists of a 24-volt 65-amp alternator and a 240 amp/hr battery. The wring is a complete circuit with one (1) wire to ground through a full breaker panel. The lighting consists of seven (7) floodlights that are mounted on the dredge. Lighting is also provided in the engine/pump compartment, on the instrument panel and overhead in the lever room.
Lever Room
	The lever room measures 1,800 mm x 1,900 mm x 1,900 mm (71 in. x 75 in. x 75 in.). All glass is LEXON 500 with 360 degree visibility. An upholstered seat is provided for the operator. The lever room is insulated for the reduction noise and for temperature control. The lever room is finished with a paneled interior.

	All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice.