Dredge Brokers - Used Dredgers (Dredges) For Sale


2,529 kW Azimuthing Thrusters w/ Controls

2,529 kW Azimuthing Thrusters w/ Controls

These 2,529 kW Azimuthing Thrusters w/ Controls were built in 2010 and are all in very good condition. All the units are stored inside and the control and electrical systems are stored in a 40' container with de-humidifier inside so there is no condensation or moisture in the air.

Available: Eight (8) Units

Located in the United Kingdom

Price per Unit: EURO 110,000

Price per Set of Two (2): EURO 216,000

Select Your Currency
Price in Seller's Preferred Currency
EUR 110,000
Price in Your Preferred Currency
USD 123,596
* Approximate; see Terms of Use

Technical Details

Principal Dimensions and Characteristics
  Year Built: 2010
  Classification Society: ABS (American Bureau of Shipping)
  Main Engine:
    Make/Model: Steerprop SP35 Azimuth Propulsors
    Power @ 1,040 RPM: 2,529 kW 3,391 hp
    Dual Inputs: at 180 degrees
  Steering Gear: The steering gear consists of electric motors connected via
    planetary gears to the slewing ring.
    Type: Electric steering gear
    Steering Drives: 2 pcs. Frequency converters
    Steering Motor: 2 pcs. AC electric motors connected to planetary gear
    Steering Power: 22 kW x 2 30 hp x 2
    Steering Speed: 18sec/180 deg
    Emergency/Service: 1 pcs built on hand reel
    Propeller Diameter: 2,800 mm 110 inches
    Propeller Type: Fixed pitch, mono-block
    Propeller Material/Finish: NiAl bronze / Class II
    Number of Blades: 4
    Propeller Shaft Speed: 239 RPM
      Moderate skew for low noise and vibration
    Nozzle Type: Steerprop HJ3-5 High Performance Nozzle,
    Nozzle Material: Mild steel grade D
    Nozzle Inside Material: Stainless Steel 3
  Stern Length: 3,350 mm 132 inches
  Basic Weight (approx.): 28,000 kg 61,729 lbs.
  Weight of Auxiliaries (approx.): 1,000 kg 2,205 lbs.
    Lubricant Volume: 2,100 liters 555 gallons
    Internal Circulation: Combined immersion and spray method
    External Circulation: 1 pcs. Electrically driven lubrication pump
    Cooling: 1 pcs. Sea water resistant tube type cooler
    Filtration: 1 pcs. filter with changeable insert
    Emergency/Service: 1 pcs built on hand pump
  Each thruster has two (2) electrical motors for steering -/ turning and one (1) electrical
motor for lubrication.

Each thruster is installed with one (1) upper and one (1) lower reduction gear unit for
dual power input.

  Each thruster is equipped with one (1) seal oil tank.
  The thruster units are constructed for low speed and high bollard pull.
  Each thruster is constructed for two (2) power inputs from electrical generators. If dual
input power is applied it demands equal revolutions per minute on both the upper and
lower gear. Alternative can one (1) input side be closed.
  Each Thruster can rotate 360 degrees and are suitable for DP (dynamic positioning).
  The number of thrusters running hours are (0).
  The steerprop thrusters have an expected life cycle of approx. 25 - 30 years.
  All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice.
Copyright © 2019