Dredge Brokers - Used Dredgers (Dredges) For Sale

170229-DH

10-inch IMS 4010-LP Dredge

10-inch IMS 4010-LP Dredge

This dredge has been recently refurbished. Many new components. 100% fully operational. 5,323 total hours. Approximately 600 hours since refurbishment. New paint, many new hydraulic hoses, new cutter motor, new impeller and wear plates, new alternator. Many spare parts including a rubber lined sand pump.

Has Starwheel® propulsion system or it can run on cables. Electronic joystick controls are provided in a heated, air-conditioned cabin. Trailer is NOT included.

Location: State of Indiana, USA

Select Your Currency
Price in Seller's Preferred Currency
USD 148,500
Price in Your Preferred Currency
USD 148,500
* Approximate; see Terms of Use

Technical Details

         
Principal Dimensions and Characteristics
  Year Built / Where Built 2000 / USA  
  Length Over All: 38.6-feet 11.77 m
  Width: 9.7-feet 2.96 m
  Height Over All: 9.4-feet 2.87 m
  Working Draft: 30-inches 0.76 m
  Weight: 25,000-pounds 11,340 kg
  Displacement: 22,400-pounds 10,160 kg
  Flotation    
    Two (2) Pontoons: 35 inches x 38-inches x 309-inches (889 mm x 965 mm x 7849 mm), 10 gauge steel sides and bottom w/ 1/4" diamond deck; internal bulkheads and stiffeners
Dredging Capacities
  Dredging Depth: 20-feet 6 m
  Width of Cut: 96-inches 2.44 m
  Nominal Depth of Cut: 22-inches 559 mm
Dredge Pump
  Make: IMS
  Discharge Diameter: 10-inches 254 mm
  Suction Diameter: 10-inches 254 mm
  Impeller Diameter 19.5-inches 495 mm
  Max. Sphere Passage: 6-inches 152 mm
  Pump Performance @1180 RPM: 3,000 gpm – 50 gallons/sec. (189 liters/sec.) @ 70 feet (21.3 m) TDH (water)
Engine
  Make / Model: John Deere Diesel / 6068HF475
  Type: 6-cylinder, 6.8-liter diesel
  Horsepower: 275 hp 205 kW
  Meter Hours 5323  
  Fuel Consumption: 13.2 gallons/hr 51.9 liters/hr
  Fuel Capacity: 180 gallons 51.9 liters/hr
Propulsion
  Starwheel Drive® Self-Propulsion System: Starwheels® are individually operated for high maneuverability
  Cable Drive system for dredging using a conventional anchor / cable system
Cutterhead
  Type Cutter Bar with replaceable hardened steel cutting edges for materials that are not easily slurried.
    Diameter 22-inches 559 mm
    Width 10-inches 254 mm
    Length 96-inches 2438 mm
  Drive Recessed dual hydraulic motor; direct drive with no gear reduction
  Speed @ 2,500 psi Variable 0 to 90 rpm
  Torque @ 2500-psi 12,960 in-lbs 1475 N-m
Electrical System
  Voltage 12-Volt, Negative ground
  Alternator Output 130 Amp
         
  All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice
Copyright 2005