Dredge Brokers - Used Dredgers (Dredges) For Sale

170313-DH

10-inch Horizontal Dredge, IMS 5012-HP - 100 total hours

10-inch Horizontal Dredge, IMS 5012-HP - 100 total hours

The dredger was built in 2006 has and has only 100 total runtime hours since new. Currently stored out oft he water, it is in like new condition. Transportable on a single truck. It has a heated and air-conditioned cabin with digital readout gauges, tinted windows, windshield wiper, and work lights. The batteries were replaced two years ago and the dredge is ready to go to work immediately.

Located: State of California, USA

Select Your Currency
Price in Seller's Preferred Currency
USD 350,000
Price in Your Preferred Currency
USD 350,000
* Approximate; see Terms of Use

Technical Details

         
Principal Dimensions and Characteristics
  Length Over All: 45-feet 5 inches 13.80 m
  Width: 11-feet 3-inches 3.40 m
  Height Over All: 10-feet 3.10 m
  Working Draft: 30-inches 762 mm
  Dry Weight: 31,000 lbs 14,100 kg
  Draft 30-inches 762 mm
  Year Built / Where Built 2006 / USA  
Dredging Capacities
  Dredging Depth: 22-feet 6.70 m
  Width of Cut: 108-inches 2743 mm
  Nominal Depth of Cut: 22-inches 559 mm
Dredge Pump
  Make: Georgia Iron Works (GIW) Cast Iron
  Suction Diameter: 10-inches 254 mm
  Discharge Diameter: 8-inches 203 mm
  Impeller Diameter 24-inches 610 mm
  Max. Sphere Passage: 4-inches 101 mm
  Performance at 143 ft (43.6 m) TDH Slurry (SG 1.25) 3.500 GPM 221 L/sec.
Engine
  Make / Model: John Deere Diesel / 6081HF070
  Type: 8.1 Liter, 6 cylinder
  Horsepower: 325 hp 242 kW
  Fuel Consumption: 15.9 gal./hr. 60.3 lit./hr.
  Fuel Capacity: 300 gal. 1136 liters
Propulsion
  Starwheel Drive® Self-Propulsion System: Starwheels® are individually operated for high maneuverability
  Cable Drive system for dredging using a conventional anchor / cable system
Cutterhead
  Type Cutter Bar with replaceable hardened steel cutting edges
    Diameter 22-inches 559 mm
    Width 10-inches 254 mm
    Length 96-inches 2438 mm
  Drive Recessed dual hydraulic motor; direct drive with no gear reduction
  Speed @ 2,500 psi Variable 0 to 90 rpm
  Torque @ 2500-psi 12,960 in-lbs 1475 N-m
Electrical System
  Voltage 12-Volt, Negative ground
  Alternator Output 130 Amp
         
  All details on these pages are given in good faith and are believed to be accurate but no warranty of accuracy or completeness or suitability for purpose is either stated or implied. Prices are subject to change without notice
Copyright 2005